AMADA NC TURRET PUNCH PRESS ARIES 245 PROGRAMMING MANUAL

When the absolute values are used for coordinate values, enter “G90” prior to the coordinate values. If the absolute values are used at the subsequent blocks of the program, it is not necessary to enter “G90” again until incremental values are used.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>