4
4. PROGRAM FORMAT
120
Program format T series M series
G92.1 0;
; Specifies axis addresses subject to the
workpiece coordinate system preset
operation. Axes that are not specified
are not subject to the preset operation.
(Supplement) G50.3 when G code system A is
used with the T series
IP
IP
f f
G94 F_ ; (M series) Feed per minute
G95 F_ ; (M series) Feed per revolution
G98 F_ ; (T series) Feed per minute
G99 F_ ; (T series) Feed per revolution
Note) Even with the T series, G94/G95 is specified
when G code system B/C is used.
f f
G96 Ss ;
G97 ; Cancel
s: Surface speed (m/min or feet/min)
f
G96 Ss Pα ;
G97 ; Cancel
P : Specify an axis on which constant surface speed
control is to be exercised.
α: 1 to 8
(X axis, Y axis, Z axis, 4th axis to 8th axis, axis
set in the PRM3770 with P0)
s: Surface speed (m/min or feet/min)
f
G98_ ;
G99_ ;
Note) With the T series, these commands are appli-
cable when G code system B/C is used.
f f