6
6.3 Matters Common to Both LCD–Mounted Type and
Stand–Alone Type i Series
252
Examples of setting
Basic module
Basic module 1
Basic module 2
Basic module 3
Basic module
Basic module 1
Basic module 2
Basic module 3
Basic module
Basic module 1
Basic module 2
Basic module 3
(When expansion module 1 is skipped)
Set the rotary switch of expansion module 2 to
setting position = 1. Do not change the setting
(setting position = 0) of expansion module 3.
(When expansion module 1 and expansion mod-
ule 2 are skipped)
Set the rotary switch of expansion module 3 to
setting position = 2.
(When expansion module 2 is skipped)
Set the rotary switch of expansion module 3 to
setting position = 1. Do not change the setting
(setting position = 0) of expansion module 1.
This function was not available initially, but was recently added. This function
became available, depending on the type of module, as indicated below.
Expansion module B (DI/
DO = 24/16, without a
manual pulse generator in-
terface)
A03B–0815–C003 Available starting with ship-
ment in June 1998 and later
Expansion module C (DO =
16, 24A output)
A03B–0815–C004 Available starting with ship-
ment in August 1998 and
later
Expansion module D (ana-
log input)
A03B–0815–C005 Available starting with ship-
ment in August 1998 and
later
NOTE To expansion module A (DI/DO = 24/16, with a manual pulse gener-
ator interface) (A03B–0815–C002), a rotary switch is added as the
other modules are modified. However, expansion module A is al-
ways installed at the location of expansion module 1, so that the
setting of expansion module A need not be changed.