7. PARAMETERS
417
07713 FL speed of C–axis acceleration/deceleration
during rotation with the hob axis and C–axis
synchronized each other [deg/min]
M series
07714 Magnification 2 for compensation of C–axis
servo delay by G83
M series
PRM
7700#3
07715 Magnification 1 for compensation of C–axis
servo delay by G83
M series
PRM
7700#3
07730 Retraction function <Axis>
M series
#0 RTR : Specifies whether the retraction function is
effective for each axis.
Retraction is enable (0)/disable (1).
07740 Feedrate during retraction for each axis
[mm/min]
<Axis>
M series
07741 Retracted distance for each axis [0.001mm] <Axis>
M series
07750 Feedrate during retraction performed when an
alarm is issued [Increment system]
<Axis>
M series
PRM
7702#3=1
07751 Amount of retraction performed when an alarm
is issued [Increment system]
<Axis>
M series
PRM
7702#3=1
07771 Number of EGB axis M series
07772 Number of position detector pulses per rotation
about tool axis [Detection unit]
M series
07773 Number of position detector pulses per rotation
about workpiece axis [Detection unit]
M series
07776 Feedrate during automatic phase
synchronization for the workpiece axis by the
automatic EGB phase synchronization function
[Increment system]
<Axis>
M series
07777 Angle shifted from the spindle position
(one–rotation signal position) the workpiece
axis uses as the reference of phase
synchronization by the automatic EGB phase
synchronization function [Increment system]
M series