OPERATION
B–63004EN/02
3. MANUAL OPERATION
487
An amount of travel is given as a numeric value, preceded by an address
such as X, Y, or Z. This is always regarded as being an incremental
command, regardless of whether G90 or G91 is specified.
The tool moves along each axis independently at the rapid traverse rate.
Linear interpolation type positioning (where the tool path is linear) can
also be performed by setting bit 1 (LRP) of parameter No. 1401.
Manual rapid traverse selection switch
Off On
Feedrate (parame-
ter)
Jog feedrate for each axis
(No. 1423)
Rapid traverse rate for
each axis (No. 1420)
Automatic accel-
eration/decelera-
tion (parameter)
Exponential acceleration/
deceleration in jog feed for
each axis (No. 1624)
Linear acceleration/decel-
eration in rapid traverse for
each axis (No. 1620)
Override Manual feed override Rapid traverse override
NOTE
When the manual rapid traverse selection switch is set to
the OFF position, the jog feedrate for each axis is clamped
such that a parameter–set feedrate, determined by bit 1
(LRP) of parameter No. 1401 as shown below, is not
exceeded.
LRP = 0 : Manual rapid traverse rate for each axis
(parameter No. 1424)
LRP = 1 : Rapid traverse rate for each axis
(parameter No. 1420)
An amount of travel is given as a numeric value, preceded by an address
such as X, Y, or Z. This is always regarded as being an incremental
command, regardless of whether G90 or G91 is specified. Axial
movements are always performed in incremental mode even during polar
coordinate interpolation. In addition, movement is always performed in
feed per minute mode regardless of the specification of G94 or G95.
Feedrate (parameter) Dry run feedrate (No. 1410)
Automatic acceleration/
deceleration (parameter)
Exponential acceleration/
deceleration in cutting feed for each
axis (No. 1622)
Override Manual feed override
NOTE
Since the feedrate is always set to the dry run feedrate,
regardless of the setting of the dry run switch, the feedrate
cannot be specified using F. The feedrate is clamped such
that the maximum cutting feedrate, set in parameter No.
1422, is not exceeded.
Explanations
D Positioning
D Linear interpolation
(G01)