PROGRAMMING
B–63094EN/02
19. HIGH SPEED CUTTING FUNCTIONS
359
In the look–ahead control mode, the functions listed below cannot be
specified. To specify these functions, cancel the look–ahead control
mode, specify the desired function, then set look–ahead control mode
again.
⋅ Rigid tapping function
⋅ Cs contour axis control function
⋅ Feed per rotation
⋅ Feed at address F with one digit
⋅ C–axis normal direction control function
⋅ Polar coordinate interpolation function
⋅ Cylindrical interpolation function
⋅ Involute interpolation function
⋅ Exponential interpolation
⋅ Three–dimensional coordinate conversion
⋅ Retrace function
⋅ Normal direction control
⋅ Polar coordinate command
⋅ Index table indexing
⋅ Tool withdrawal and return
⋅ Threading and synchronous feed
⋅ High–speed cycle machining
⋅ Handle interrupt
⋅ Program restart
⋅ Simplified synchronization control
⋅ Feed stop
⋅ High–speed skip function
⋅ Constant surface speed control
⋅ Interrupt type custom macro
⋅ Small–diameter peck drilling cycle
⋅ High–speed remote buffer A/B
⋅ Automatic tool length measurement
⋅ Skip cutting
⋅ G28 (low–speed reference position return)
D Functions that cannot be
specified