APPENDIXA. ALARM LIST
B–63525EN/02
854
Number ContentsMessage
5060 ILLEGAL PARAMETER IN
G02.3/G03.3
(M series)
There is a parameter setting error.
Parameter No. 5641 (setting of the linear axis) is not set.
The axis set in parameter No. 5641 is not a linear axis.
Parameter No. 5642 (setting of a rotation axis) is not set.
The axis set in parameter No. 5642 is not a rotation axis.
The linear and rotation axes cannot be controlled by the CNC. (The val-
ue set in parameter No. 1010 is exceeded.)
5061 ILLEGAL FORMAT IN G02.3/G03.3
(M series)
The exponential interpolation command (G02.3/G03.3) has a format er-
ror.
Address I, J, or K is not specified.
The value of address I, J, or K is 0.
5062 ILLEGAL COMMAND IN
G02.3/G03.3
The value specified in an exponential interpolation command
(G02.3/03.3) is illegal. A value that does not allow exponential interpola-
tion is specified. (For example, a negative value is specified in In.)
5063 IS NOT PRESET AFTER REF.
(M series)
Function category:
Workpiece thickness measurement
Alarm details
The position counter was not preset before the start of workpiece thick-
ness measurement. This alarm is issued in the following cases:
(1) An attempt has been made to start measurement without first estab-
lishing the origin.
(2) An attempt has been made to start measurement without first pre-
setting the position counter after manual return to the origin.
5064 DIFFERRENT AXIS UNIT (IS–B,
IS–C)
(M series)
Circular interpolation has been specified on a plane consisting of axes
having different increment systems.
5065 DIFFERENT AXIS UNIT (PMC AXIS)
(M series)
Axes having different increment systems have been specified in the
same DI/DO group for PMC axis control. Modify the setting of parameter
No. 8010.
5067 G05 PO COMMANDED IN G68/G51
MODE
(HPCC) (M series)
HPCC mode cannot be canceled during G51 (scaling) or G68 (coordi-
nate system rotation).
Correct the program.
5068 G31 FORMAT ERROR
(M series)
The continuous high–speed skip command (G31 P90) has one of the
following errors:
1. The axis along which the tool is moved is not specified.
2. More than one axis is specified as the axis along which the tool is
moved.
Alternatively, the EGB skip command (G31.8) or continuous high–
speed skip command (G31.9) has one of the following errors:
1. A move command is specified for the EGB axis (workpiece axis).
2. More than one axis is specified.
3. P is not specified.
4. The specified Q value exceeds the allowable range.
Correct the program.
5069 WHL–C:ILLEGA
P–DATA
(M series)
The P data in selection of the grinding–wheel wear compensation cen-
ter is illegal.
5073 NO DECIMAL POINT No decimal point has been specified for an address requiring a decimal
point.
5074 ADDRESS DUPLICATION ERROR The same address has been specified two or more times in a single
block. Alternatively, two or more G codes in the same group have been
specified in a single block.
5082 DATA SERVER ERROR This alarm is detailed on the data server message screen.