4.DESCRIPTION OF PARAMETERS B-63790EN/01
- 186 -
#7 #6 #5 #4 #3 #2 #1 #0
2401 NCM MBF G18 G95 G44 G43 G90 G01
[Input type] Parameter input
[Data type] Bit
#0 G01 Mode at power on and in clear status
0: G00 mode (positioning)
1: G01 mode (linear interpolation)
#1 G90 Mode at power on and in clear status
0: G91 mode (incremental command)
1: G90 mode (absolute command)
#2 G43
#3 G44 G43 and G44 set G43, G44, or G49 mode to be entered when power is
turned on and when clear operation is performed (for M series only) .
G43 G44 G43, G44, or G49 mode
0 0 G49 mode
0 1 G44 mode
1 0 G43 mode
#4 G95 Mode at power on and in clear status
0: G94 mode (feed per minute)
1: G95 mode (feed per revolution)
#5 G18 Mode at power on and in clear status
0: G17 mode
1: G18 mode
#6 MBF Selects or cancels the multibuffer mode at power on and in the clear
state.
0: Cancels the multibuffer mode.
1: Selects the multibuffer mode. (When the optional multibuffer
15-block/100-block function is not provided, five buffer blocks
are used for the look-ahead operation.)
When the multibuffer mode is selected, acceleration/deceleration
before look-ahead interpolation is enabled at the same time.
If the fine HPCC option is provided, fine HPCC mode is enabled at
the same time.
NOTE
This parameter becomes valid when the system is
reset.
#7 NCM Specifies whether the following modal information is cleared by
reset:
0: Cleared
1: Not cleared but saved.
G00 to G03 (except G06.2) , G17 to G19, G17.1, G93 to G95, G96 to
G97, G90 to G91, F codes, S codes, and T codes