8.COMMENT OF SOFT-KEYS IN ALL-IN-ONE SCREEN USER PROGRAM B-63343EN/02
- 122 -
3) Soft-key group #3 for editing or executing taught-in blocks
By pushing a [+] at the time of the above soft-key group #1 or #2
being displayed, following soft-key group is displayed.
SAVE TOOL CHECK HEAD EXEC
SAVE : Save the current taught-in blocks as a playback
machining program
TOOL : Call tool list
CHECK : Prepare checking by tool path drawing
HEAD : Return to the top of this process
EXEC : Begin a playback machining of this process
4) Soft-key group #4 displayed in a program list window
By pushing a [SAVE] in the soft-key group #3, a program list is
displayed in a pop-up window, and the following soft-key group
for saving taught-in blocks are displayed.
NEW ADD CANCEL
NEW : Make a new playback machining program, and enter
whole current taught-in blocks into it.
ADD : Add whole current taught-in blocks at the end of the
selected playback machining program. This program
can be selected by inputting a program number by
numeric keys.
CANCEL : Close a program list pop-up window.
5) Soft-keys group #5 for one-shot machining simulation
By pushing a [CHECK] in the soft-key group #3, the following
soft-key group for one-shot machining simulation are displayed.
SPD UP SPD DW PLOT HEAD RETURN EXEC SINGLE
RETURN : Get out from one-shot machining simulation mode,
and return to the old screen.
As to soft-keys other than [RETURN], they are quite similar to
the ones for tool path drawing simulation, so refer to 8.5 1).