PROGRAMMING
B–63844EN/02
19. HIGH SPEED CUTTING
FUNCTIONS
371
⋅ External deceleration
⋅ Simple synchronous control
⋅ Sequence number comparison and stop
⋅ Position switch
(Bit 3 (PSF) of parameter No. 6901 can be set to also use this function
in the advanced preview control mode. Setting this parameter to 1
changes the timing when the signal is output. So, it may become
necessary to change the ladder.)
⋅ Cs contour control
(Bit 5 (G8S) of parameter No. 1602 can be set to also use this function
in the advanced preview control mode. The serial spindle parameters
must also be set.)
⋅ Constant surface speed control
⋅ Spindle synchronous control
⋅ Simple spindle synchronization
⋅ Custom macro B
⋅ Arbitrary angle chamfering/corner rounding
⋅ Inch/metric conversion
⋅ Programmable mirror image
⋅ Canned cycle
⋅ Automatic corner override
(Only the internal circular cutting feedrate change is valid.)
⋅ Scaling
⋅ Coordinate system rotation
⋅ Workpiece coordinate system
⋅ Workpiece coordinate system preset
⋅ Cutter compensation C
⋅ Corner circular interpolation
⋅ Tool offset
⋅ Tool life management
⋅ Tool length measurement
⋅ Graphic display
⋅ Dynamic graphic display
⋅ Feed per revolution