1.MANUAL GUIDE 0i MANUAL GUIDE 0i B-63844EN/02
- 756 -
(4) When the preceding figure is pending (for which the start point
has been determined), and "TOUCH LAST" is specified in the
arc
(a) R, I an K are inputted
-> The tangential point is calculated, and this arc will be
pending.
(b) X, Y, I and J are inputted
-> The tangential point is calculated, and this arc will be
determined.
NOTE
If the distance (radius) between the start point and
center differs from the end point and center, the
figure is displayed based on the actual form, and the
actual figure will not be machined correctly.
(c) R and X, Y are inputted
-> The selection screen for either "Long path arc" or
"Short path arc" is displayed, so select a necessary
one.
Tangential point
R
Center (I,J)
Tangential point
Center (I,J)
End point
(X,Y)
Long
path arc
R
R
End point (X,Y)
Tangential point
Tangential point
Short path arc