1.8.5 ENTERING A MACHINNING TYPE OF CANNED CYCLE
Display Main menu as described ‘1.8.1 START UP’. Select the machinning
type (Hole, Face, Pocket or Groove) by depressing the soft key on the Main
menu.
For example, when an operator selects Pocket machinning, the following
machinning menu appears.
When an operator selects a machinning type by depressing the soft
key.The following data input screen appears.
Input necessary data and depress the soft key [FIGURE]. The figure block
is inserted into the machinning program. And, the Figure menu appears.
Please refer to ‘IV. 1.4.2 DATA FOR EACH CANNED CYCLE’ about the
details of input data on CANNED cycle screen.
Ed.
Date
Design
Description
Name
Draw.
FANUC Series 0i-MB
OPERATOR’S MANUAL
B-63844EN/02-1
Page
FANUC LTD.
10/16