FANUC Series 30i/31i/32i-MODEL A Additional Manual Page 1

Additional Manual
A-79723EN
Title
Draw
No.
Ed. Date Design Description
Date Jan.12.’05 Design. Apprv.
1/1
page
FANUC Series 30i/31i/32i-MODEL A
Rotary switch setting of Stand-alone type CNC
FANUC Series 30i/31i/32i -MODEL A
Rotary switch setting of Stand-alone type CNC
In case of Stand-alone type FANUC Series 30i/31i/32i -MODEL A, difference by the
setting of rotary switch is as follows. The behavior depends on the edition of BOOT
software.
Setting
60W1-10
or later 60W1-09 or former
0
(a)Normal condition
E
(b)Not wait display
(b)
Not wait display
F
(c)Maintenance mode (c)Maintenance mode
(a) Normal condition
1. CNC waits until connection between HSSB device starts.
2. BOOT, IPL menu, power on status are not displayed.
(b) Not wait display
1. CNC starts up without waiting connection between HSSB device.
2. BOOT, IPL menu, power on status are not displayed.
(c) Maintenance mode
1. CNC waits until connection between HSSB device starts.
2. BOOT, IPL menu, power on status are displayed in order.
Note
By pressing MDI numeric key 6 and 7 and turn the power ON, the
behavior becomes “(c) Maintenance mode” even if the rotary switch
setting is 0 or E.

Contents Summary of FANUC Series 30i/31i/32i-MODEL A Additional Manual

  • Page 1FANUC Series 30i/31i/32i -MODEL A Rotary switch setting of Stand-alone type CNC In case of Stand-alone type FANUC Series 30i/31i/32i -MODEL A, difference by the setting of rotary switch is as follows. The behavior depends on the edition of BOOT software. Setting 60W1-10 or later 60W1-09 or former 0