FANUC Series 30i/31i/32i-MODEL A Additional Manual Page 2

Additional Manual

A PHP Error was encountered

Severity: Warning

Message: file_get_contents(http://cdn.cncmanuals.com/data/fanuc/374/page-2.html): failed to open stream: HTTP request failed! HTTP/1.1 404 Not Found

Filename: _parts/post_content_view.php

Line Number: 125

Backtrace:

File: /home/stinkbea/cncmanuals.com/application/views/templates/_parts/post_content_view.php
Line: 125
Function: file_get_contents

File: /home/stinkbea/cncmanuals.com/application/views/templates/post_view.php
Line: 4
Function: view

File: /home/stinkbea/cncmanuals.com/application/core/MY_Controller.php
Line: 151
Function: view

File: /home/stinkbea/cncmanuals.com/application/controllers/Home.php
Line: 36
Function: render_post

File: /home/stinkbea/cncmanuals.com/index.php
Line: 315
Function: require_once

Contents Summary of FANUC Series 30i/31i/32i-MODEL A Additional Manual

  • Page 1FANUC Series 30i/31i/32i -MODEL A Rotary switch setting of Stand-alone type CNC In case of Stand-alone type FANUC Series 30i/31i/32i -MODEL A, difference by the setting of rotary switch is as follows. The behavior depends on the edition of BOOT software. Setting 60W1-10 or later 60W1-09 or former 0