B--63003EN--1/02
11. PROGRAM COMMAND
1017
5170 Number of the macro variable to which the total number of retractions during cutting
is output
[Data type] Word
[Valid data range] 100 to 149
This parameter sets the number of the macro variable to which the total
number of times the tool is retracted during cutting in a peck drilling cycle
mode of a small diameter is output. The total number cannot be output to
common variables 500 to 599.
5171 Number of the macro variable to which the total umber of retractions because of an
overload signal is output
[Data type] Word
[Valid data range] 100 to 149
This parameter sets the common variable number of the custom macro to
which the number of times the tool is retracted after the overload signal is
received during cutting in a peck drilling cyclemode of a small diameteris
output. The total number cannot be output to common variables 500 to
599.
5172 Speed of retraction to point R when no address I is issued
[Data type] Word
[Unitofdata] mm/min
[Valid data range] 0 to 4000
This parameter sets the speed of retraction to point R when no address I is
issued in a peck drilling cycle of a small diameter.
5173 Speed of advancing to the position just before the bottom of a hole when no ad-
dress I is issued
[Data type] Word
[Unitofdata] mm/min
[Valid data range] 0 to 4000
This parameter sets the speed of advancing to the position just before the
bottom of a previously machined hole when no address I is issued in a
peck drilling cycle of a small diameter.