15. PMC CONTROL FUNCTION
B--63003EN--1/02
1244
#7
8003
#6 #5 #4 #3 #2 #1 #0
PIM
NOTE
When this parameter is set, the power must be turned off
then back on again to make the setting effective.
[Data type] Bit type
PIM If a linearaxis is controlled solely by the PMC, the commands for that axis
are:
0 : Affected by inch/metric input.
1 : Not affected by inch/metric input.
#7
NDI8004
#6
NCI
NCI
#5
DSL
DSL
#4
G8R
G8R
#3
G8C
G8C
#2
JFM
JFM
#1
NMT
NMT
#0
CMV
CMV
[Data type] Bit type
CMV If the PMC issues a command for an axis after the completion of a
movement along that axis according to a command issued by the CNC,
but before receiving the signal indicating that the miscellaneous function
is completed in the same block,
0 : P/S alarm No. 130 occurs.
1 : The axis is handled as a PMC axis and the specified movement is
executed.
NMT If the CNC issues a command that does not result in any movement along
a PMC--controlled axis while another command, specified for the axis, is
being processed,
0 : P/S alarm No. 130 occurs.
1 : No alarm occurs.
JFM Specifies the units used to specify the feedrate for continuous feed (06H)
for a PMC--controlled axis.
Increment
system
JFM Metric input Inch input Rotation axis
0 1 mm/min 0.01 inch/min 0.00023 rpm
--
1 200 mm/min 2.00 inch/min 0.046 rpm
0 0 .1 mm/min 0.001 inch/min 0.000023 rpm
--
1 20 mm/min 0.200 inch/min 0.0046 rpm
G8C If a cutting feed command is specified for a PMC--controlled axis,
look--ahead control is:
0 : Disabled.
1: Enabled.