B--63003EN--1/02
2. PREPARATIONS FOR OPERATION
273
#7
8100
#6 #5 #4 #3 #2 #1
IAL
#0
RST
[Data type] Bit
RST Reset key on the MDI panel
0 : Effective for both paths
1 : Effective for the path selected by the path select signal
IAL When an alarm is raised in one tool post in the automatic operation mode,
0 : The other path enters the feed hold state and stops.
1 : The other path continues operation without stopping.
3141 Path name (1st character)
3142 Path name (2nd character)
3143 Path name (3rd character)
3144 Path name (4th character)
3145 Path name (5th character)
3146 Path name (6th character)
3147 Path name (7th character)
[Data type] Byte type
Specify a path name with codes (two--path control).
Any character strings consisting of alphanumeric characters and symbols
(up to seven characters) can be displayed as path names on the screen,
instead of HEAD1 and HEAD2 for T series, and instead of PATH1 and
PATH2 for M series.
NOTE
1 This parameter is dedicated to the two--path control.
2 Specify these parameters for each series.
3 For characters and codes, see the correspondence table in
2.1.15 software operator’s panel.
4 When codes are 0, HEAD1 and HEAD2 for T series and
PATH1 or PATH2 for M series are displayed.
Parameter
Parameters for displa y of
optional path names