6. INTERPOLATION FUNCTION
B--63003EN--1/02
468
1627 FL rate of exponential acceleration /deceleration in the thread cutting
cycle for each axis
[Data type] Word axis
Valid data range
ncrement system
n
to
ata
I S --- A , I S --- B I S --- C
Millimeter machine 1 mm/min 6 -- 15000 6 -- 12000
Inch machine 0.1 inch/min 6 -- 6000 6 -- 4800
Rotaio n axis 1 deg/min 6 -- 15000 6 -- 12000
Set the lower limit (FL rate) of exponential acceleration/deceleration in
the thread cutting cycle (G76, G78 (G92 in G code system A)) for each
axis.
5130 Chamfering distance in the thread cutting cycles G76 and G92
[Data type] Byte
[Unitofdata] 0.1 pitch
[Valid data range] 0to127
This parameter sets the chamfering in the thread cutting cycles G76 and
G92.
5140 Minimium depth of cut in the multiple repetitive canned cycle G76
[Data type] Two--word
Increment system IS--A IS--B IS--C Unit
Metric input 0.01 0.001 0.0001 mm
Inch input 0.001 0.0001 0.00001 inch
[Valid data range] 0 to 99999999
This parameter sets the minimum depth of cut in the multiple repetitive
canned cycle G76.
Setting the FL feedrate
for the thread cutting
cycle
[Unitofdata]
[Valid data range]
Setting the chamfering
distance for the thread
cutting cycle
Setting the minimum
depth of cut for the
multiple repetitive
canned cycle G76
[Unitofdata]