B--63003EN--1/02
9. SPINDLE SPEED FUNCTION
808
3822 Maximum speed of the third spindle
[Data type] Word
[Unitofdata] rpm
[Valid data range] 0 to 32767
This parameter sets the maximum speed for the third spindle.
When a command specifying a speed exceeding the maximum spindle
speed is specified, or the spindle speed exceeds the maximum speed
because of the spindle speed override function, the spindle speed is
clamped at the maximum speed set in the parameter.
WARNING
1 When 0 is set in this parameter, the setting of parameter No.
3772 for the first spindle is used. When 0 is set in parameter
No. 3772, the spindle speed is not clamped.
2 When spindle speed command control is applied using the
PMC, this parameter has no effect, and the speed of the
spindle is not clamped.
NOTE
1 This parameter is valid when the multi-- spindle control
option is selected.
2 When the constant surface speed control option is selected,
the spindle speed is clamped at the specified maximum
speed, regardless of whether the G96 mode or G97 mode
is set.
3831 Maximum spindle speed for gear 1 of the third spindle
3832 Maximum spindle speed for gear 2 of the third spindle
[Data type] Word
[Unitofdata] rpm
[Valid data range] 0 to 32767
Set the maximum spindle speed for each gear of the third spindle.
NOTE
These parameters are used for muliti-- spindle control.