10. TOOL FUNCTIONS
B--63003EN--1/02
918
#7
TL128G047
#6
TL64
#5
TL32
#4
TL16
#3
TL08
#2
TL04
#1
TL02
#0
TL01
TLRSTG048 TLRSTI TLSKP TL256
*TLV7G049 *TLV6 *TLV5 *TLV4 *TLV3 *TLV2 *TLV1 *TLV0
G050 *TLV9 *TLV8
#7
F064
#6 #5 #4 #3 #2
TLCHI
#1
TLNW
#0
TLCH
#7 #6 #5 #4 #3 #2 #1 #0
6800
M6T IGI
SNG GRS SIG LTM GS2 GS1
SNG GRS SIG LTM GS2 GS1
[Data type] Bit
GS1, GS2 This parameter sets the combination of the number of tool life groups
which can be entered, and the number of tools which can be entered per
group as shown in the table below.
M series T series
2
1
Group count Tool count Group count Tool count
0 0 1-- 16
1-- 64
1-- 16
1-- 32
1-- 16
1-- 16
1-- 16
1-- 32
0 1 1-- 32
1--128
1-- 8
1-- 16
1-- 32
1-- 32
1-- 8
1-- 16
1 0 1-- 64
1--256
1-- 4
1-- 8
1-- 64
1-- 64
1-- 4
1-- 8
1 1 1--128
1--512
1-- 2
1-- 4
1-- 16
1--128
1-- 16
1-- 4
Lower side ranges in M series column are for the tool life management of
512 pairs.
Lower side range in T series column are for tool life management of 128
pairs.
LTM Tool life
0 : Specified by the number of times
1 : Specified by time
SIG Group number is
0 : Not input using the tool group number selection signal during tool
skip (The current group is specified.)
1 : Input using the tool group signal during tool skip
GRS Tool change reset signal
0 : Clears only the execution data of a specified group
1 : Clears the execution data of all entered groups
Signal address
Parameter