B--63003EN--1/02
11. PROGRAM COMMAND
957
NOTE
Setting value 0 is invalid. No custom macro can be called
by M00.
6080 M code that calls the custom macro of program number 9020
6081 M code that calls the custom macro of program number 9021
6082 M code that calls the custom macro of program number 9022
6083 M code that calls the custom macro of program number 9023
6084 M code that calls the custom macro of program number 9024
6085 M code that calls the custom macro of program number 9025
6086 M code that calls the custom macro of program number 9026
6087 M code that calls the custom macro of program number 9027
6088 M code that calls the custom macro of program number 9028
6089 M code that calls the custom macro of program number 9029
[Data type] Two--word
[Valid data range] 1 to 99999
These parameters set the M codes that call the custom macros of program
numbers 9020 through 9029.
NOTE
Setting value 0 is invalid. No custom macro can be called
by M00.
6090 ASCII code that calls the subprogram of program number 9004
6091 ASCII code that calls the subprogram of program number 9005
[Data type] Byte
[Valid data range] 65 (A:41H) to 90 (Z:5AH)
These parameters set the ASCII codes that call subprograms in decimal.
Addresses that can be used are as follows:
T series : A, B, F, H, I, K, M, P, Q, R, S, T
M series: A, B, D, F, H, I, J, K, L, M, P, Q, R, S, T, X, Y, Z
NOTE
Set 0 when no subprogram is called
D Setting M codes that call
custom macros of
no.9020 to 9029
D ASCII codes that call
subprogram of program
No. 9004 and 9005