PROGRAMMING5. FEED FUNCTIONS
B–63534EN/02
114
Dwell G04 X_ ; or G04 P_ ;
X_ : Specify a time or spindle speed (decimal point permitted)
P_ : Specify a time or spindle speed (decimal point not permitted)
By specifying a dwell, the execution of the next block is delayed by the
specified time. In addition, a dwell can be specified to make an exact
check in the cutting mode (G64 mode).
When neither P nor X is specified, exact stop is performed.
Bit 1 (DWL) of parameter No. 3405 can specify dwell for each rotation
in feed per rotation mode (G95).
Table 5.5 (a) Command value range of the dwell time
(Command by X)
Increment system Command value range Dwell time unit
IS–B 0.001 to 99999.999
IS–C 0.0001 to 9999.9999
s or rev
Table 5.5 (b) Command value range of the dwell time
(Command by P)
Increment system Command value range Dwell time unit
IS–B 1 to 99999999 0.001 s or rev
IS–C 1 to 99999999 0.0001 s or rev
5.5
DWELL (G04)
Format
Explanations