17. PROGRAMMABLE DATA
G10L50; Parameter entry mode setting
N_R_; For parameters other than the axis type
N_P_R_; For axis type parameters
G11; Parameter entry mode cancel
N_: Parameter No. (5digits) or compensation posi
tion No. for pitch errors compensation +10,000 (5digit)
R_: Parameter setting value (Leading zeros can be omitted.)
P_: Axis No. 1 to 8 (Used for entering axis type parameters)
Meaning of command
Do not use a decimal point in a value set in a parameter (R_).
a decimal point cannot be used in a custom macro variable for R_
Specify an axis number (P_) from 1 to 8 (up to eight axes) for an axis type
parameter. The control axes are numbered in the order in which they are
displayed on theCNC display.
For example, specity P2 for the control axis which is displayed second.
1 Do not fail to perform reference point return manually after
changing the pitch error compensation data or backlash
compensation data. Without this, the machine position can
deviate from the correct position.
2 For processing which reads multiple blocks in advance,
such as that in cutter compensation mode, rewriting a
parameter using G10 will cause that parameter to change
during machining. In such a case, therefore, specify a G40
command (to cancel cutter compensation mode), before
3 In principle, specify G10 after stopping command
distribution by, for example, specifying an M code which
If a PMC axis is operating while the machining program is
being executed, specifying G10 in the machining program
causes parameter rewriting to wait until command
distribution to the PMC axis is stopped. In such a case, the
execution of the machining program is also caused to wait.
D Parameter setting
D Axis No.(P_)