OPERATION2. OPERATIONAL DEVICES
Procedure of turning on the power
1 Check that the appearance of the CNC machine tool is normal.
(For example, check that front door and rear door are closed.)
2 Turn on the power according to the manual issued by the machine
3 After the power is turned on, check that the position screen is
displayed. If the screen shown in Section 2.4.2 is displayed, a system
failure may have occurred.
MEM STRT MTN *** 09:06:35
[ ABS ] [ REL ] [ ALL ] [ HNDL ] [ OPRT ]
ACTUAL POSITION(ABSOLUTE) O1000 N00010
PART COUNT 5
RUN TIME 0H15M CYCLE TIME 0H 0M38S
ACT.F 3000 MM/M S 0 T0000
Fig. 2.5.1 Position screen (Seven soft key type)
4 Check that the fan motor is rotating.
When pressing the <POWER ON> key, do not touch any
other LCD/MDI panel keys. Until the positional or alarm
screen is displayed, do not touch them. Some keys are
used for the maintenance or special operation purpose.
When they are pressed, unexpected operation may be
Turning on the Power