FANUC Power Mate i Supplement to Manual Page 1
Supplement to Manual
B-63173EN-1/02-3
Edit
Apprv.
Desig.
Sheet
Title
Draw
No.
1/3
Date
Design
Descri
p
tion
Date
FANUC Power Mate i –MODEL D/H
Parameter write, protection signal
FANUC Power Mate i – MODEL D/H
Parameter write, protection signal
１．Type of applied technical documents
Name FANUC Power Mate i –MODEL D/H
CONNECTION MANUAL （FUNCTION）
Spec. No./Version B-63173EN-1/02
２．Summary of Change
Group Name／Outline New, Add, Applicable
Correct, Date
Delete
Basic Parameter write, protection signal Add Immediate
Function
Optional
Function
Unit
Maintenance
Parts
Notice This function is supported by following series/ edition or later.
Power mate i-MODEL D 88E0-24(X) or later.
Power Mate i-MODEL H 88F2-07(G) or later,
88F1/15(O) or later.
Correction
Another
040519
Contents Summary of FANUC Power Mate i Supplement to Manual
- Page 1FANUC Power Mate i – MODEL D/H Parameter write, protection signal １．Type of applied technical documents Name FANUC Power Mate i –MODEL D/H CONNECTION MANUAL （FUNCTION） Spec. No./Version B-63173EN-1/02 ２．Summary of Change Group Name／Outline New, Add, Applicable Correct, Date Delete Basic Parameter wr
- Page 2Replace the description of the chapter “2.14 Memory Protection Key” with the following. 2. 14 Memory Protection Key General A key called the data protection key is used to prevent part programs, offset values, parameters, and setting data from being registered, modified, or deleted erroneously. And
- Page 3Signal Address #7 #6 #5 #4 #3 #2 #1 #0 G046 KEY4 KEY3 KEY2 KEY1 KEYP Parameter No. #7 #6 #5 #4 #3 #2 #1 #0 3290 KEY Data type: bit KEY Four memory protection keys: 0: The KEY1, KEY2, KEY3 and KEY4 signal are used. 1: Only the signal KEY1 used. NOTE The functions of the signals depend on whether KEY