B-66284EN/01 2.DEVELOPMENT OF CUSTOM SCREEN
- 257 -
2.4.4 Drawing of Arc
This control draws the arc determined by a start point, end point,
center, and arc drawing rotation direction.
The start point, end point, or center can be dragged on a screen form.
When the start point or end point is dragged, the center may position
outside the screen form depending on the positions of the start point
and end point, making the center invisible.
Property Pages
- General
Object ID:
Object ID managed in the form. This ID is automatically
assigned, so that the user cannot set this ID.
X, Y:
Set the coordinates of the upper-left corner of a rectangle.
Width, Height:
Set the width and height of the rectangle.
Direction:
CW: Clockwise
X1, Y1:
X coordinate and Y coordinate of an arc drawing start point
X2, Y2:
X coordinate and Y coordinate of an arc drawing end point
Xc, Yc:
X coordinate and Y coordinate of an arc drawing center