16. HIGH SPEED CUTTING FUNCTIONS
(2) When G00 is specified with bit 7 of parameter SG0 No. 8403 set to 1,
the following points should be noted:
⋅Since the G00 command is replaced by the G01 command, the beam
moves at the feedrate set in parameter No. 8481 even when data is
specified for two axes.
Example) If the following is specified when parameter No. 8481 is
set to 1000 mm/min, F1000 is used instead of F1414
G00 X100. Y100. ;
D Since the G00 command is replaced by the G01 command, rapid
traverse override is disabled and cutting feed override is enabled.
D For acceleration/deceleration after interpolation, the time constant
used for cutting feed acceleration/deceleration after interpolation
D Linear and bell–shaped acceleration/deceleration before inter–
polation in HPCC mode is enabled.
D No position check is performed.
D Linear interpolation type positioning is performed.
When G05P10000 is specified, “HPCC” starts blinking at the right–
bottom of the screen. While “HPCC” is blinking, the system performs
automatic operation in HPCC mode.
MEM STRT MTN * * *
01 : 23 : 45 HPCC
G05 P10000 ; Executed block
N10 X10. Y10. Z10. ; Block being executed
N20 X10. Y10. Z10. ;
/ N30 X10. Y10. Z10. ;
/2 N40 X10. Y10. Z10. ;
N50 X10. Y10. Z10. ;
N60 X10. Y10. Z10. ;
N70 (FANUC Series 16) ;
N80 X10. Y10. Z10. ;
N90 X10. Y10. Z10. ;
N100 X10. Y10. Z10. ;
N110 X10. Y10. Z10. ;
G05 P0 ;
Display example for when the system is in HPCC mode
D Status display