PROGRAMMING16. HIGH SPEED CUTTING FUNCTIONS
B–63664EN/02
326
Tool compensation functions
f : Can be specified. : Cannot be specified.
Name Function
Tool function (Txxxx) f The function code and function strobe signals
are output only.
Tool offset memory B f
Tool offset memory C f
Tool offset (G45 to G48)
Cutter compensation C
(G40, G41, G42)
f
Other functions f : Can be specified. : Cannot be specified.
Name Function
Cycle start/feed hold f
Dry run f
Single block f
Sequence number comparison
and stop
f
Program restart f For the time constant for acceleration/decelera-
tion during movement to the restart position,
the following parameters are used:
When exponential acceleration/deceleration is
used: Parameter Nos. 1624 and 1625
When linear/bell–shaped acceleration/decel-
eration is used: Parameter No. 1622
To set the acceleration/deceleration type, use
bits 0 and 1 of parameter No. 1610.
Macro executor
(execution macro)
MDI operation f
Manual intervention f
NOTE
1 The above tables include a function that another option is
required for specifying.
2 Multiple blocks are not read in advance.
When G05.1 Q1 is specified, the modal G codes must be set as listed
below. If one of these conditions is satisfied, a PS5111 alarm occurs.
G code(s) Description
G00
G01
G02
G03
Positioning
Linear interpolation
Circular interpolation (CW)
Circular interpolation (CCW)
G13.1 Polar coordinate interpolation cancel mode
G15 Polar coordinate command cancel
G40 Cutter compensation cancel
G40.1 Normal direction control cancel mode
G50 Scaling cancel
G50.1 Programmable mirror image cancel
G64 Cutting mode
G67 Macro modal call cancel
G69 Coordinate system rotation cancel
G94 Feed per minute
D Conditions for setting the
AI contour control/AI
nano contour control
mode