OPERATION3. MANUAL OPERATION
B–63664EN/02
476
Parameter JHD (bit 0 of No. 7100) enables or disables the manual handle
feed in the JOG mode.
When the parameter JHD( bit 0 of No. 7100) is set 1,both manual handle
feed and incremental feed are enabled.
Parameter THD (bit 1 of No. 7100) enables or disables the manual handle
feed in the TEACH IN JOG mode.
Parameter HPF (bit 4 of No. 7100) or (No. 7117) specifies as follows:
• Parameter HPF (bit 4 of No. 7100)
Set value 0 : The feedrate is clamped at the rapid traverse rate and
generated pulses exceeding the rapid traverse rate are
ignored.(The distance the nozzle is moved may not
match the graduations on the manual pulse generator.)
Set value 1 : The feedrate is clamped at the rapid traverse rate and
generated pulses exceeding the rapid traverse rate are not
ignored but accumulated in the CNC.
(No longer rotating the handle does not immediately stop
the nozzle. The nozzle is moved by the pulses
accumulated in the CNC before it stops.)
• Parameter HPF (No. 7117) (It is available when parameter HPF is 0.)
Set value 0 : The feedrate is clamped at the rapid traverse rate and
generated pulses exceeding the rapid traverse rate are
ignored.(The distance the nozzle is moved may not
match the graduations on the manual pulse generator.)
Other than 0 : The feedrate is clamped at the rapid traverse rate and
generated pulses exceeding the rapid traverse rate are not
ignored but accumulated in the CNC until the limit
specified in parameter No. 7117 is reached.
(No longer rotating the handle does not immediately stop
the nozzle. The nozzle is moved by the pulses
accumulated in the CNC before it stops.)
Parameter HNGx (No. 7102 #0) switches the direction of MPG in which
the nozzle moves along an axis, corresponding to the direction in which
the handle of the manual pulse generator is rotated.
Explanations
D Availability of manual
pulse generator in Jog
mode (JHD)
D Availability of manual
pulse generator in
TEACH IN JOG mode
(THD)
D A command to the MPG
exceeding rapid traverse
rate (HPF)
D Movement direction of
an axis to the rotation of
MPG (HNG
X
)