OPERATION15. LASER FUNCTION
The time data is updated when the oscillator is in the LSTR
and subsequent later stages. When LSTR is turned off, the
values present at this point of time are maintained. When
the automatic aging function is disabled (bit 6 of parameter
No. 15008 is set to 0), however, the time data is not updated.
Name Remaining time
Meaning An estimated remaining time of the aging operation in-
cluding the power compensation operation is indicated in
minutes. Because the indicated value is an estimated
value, it may differ from the actual operation time.
Valid data range This item can be referenced only. No value can be set.
Name Manual mode (0: Off, 1: On)
Meaning This item is set to 0 at CNC power–up. When RUN–ON
is performed after this item is set to 1, the aging opera-
tion is performed as many times as the number set as
the “No. of manual operations” regardless of whether the
aging function is enabled or disabled and of the period in
which the oscillator has been stopped. When aging is
completed, and the LSTR state is entered, this item is set
to 0 automatically. Even when this item is set to 1 after
RUN–ON, this item does not become effective, and
manual aging by this item is not started. The value set in
this item is determined at the time of RUN–ON, so even
when the setting of this item is changed during aging
operation, the operation does not change.
Valid data range 0 or 1
Name No. of manual operations
Meaning Set the number of times aging is to be performed when
the aging operation is started manually. If bit 4 of param-
eter No. 15014 is set to 0, the CNC sets this item to 2. If
bit 4 of parameter No. 15014 is set to 1, a value from 2 to
255 can be set.
Valid data range 2 to 255