APPENDIXG. ALARM LIST
5046 ILLEGAL PARAMETER (ST.COMP) An illegal parameter has been specified for straightness compensa-
Possible reasons are as follows:
1 There is no axis corresponding to the axis number specified in the
move axis or compensation axis parameter.
2 More than 128 pitch error compensation points are not sequentially
3 The straightness compensation points are not sequentially num-
4 A specified straightness compensation point is outside the range
between the pitch error compensation points having the maximum
positive and negative coordinates.
5 The compensation value specified for each compensation point is
too large or too small.
5051 M–NET CODE ERROR When the chopping function is used, a move command was specified
for a chopping axis in chopping mode (during reciprocation between
a top dead point and bottom dead point).
5052 M–NET ETX ERROR “ETX” code is abnormal.
5053 M–NET CONNECT ERROR Connection time supervision error (parameter No.175)
5054 M–NET RECEIVE ERROR Boring time supervision error (parameter No.176)
5055 M–NET PRT/FRM ERROR Vertical parity or framing error detection
5057 M–NET BOARD SYSTEM DOWN Transmit time–out error (parameter No. 177)
ROM parity error
CPU interruption detection of not listed above
5059 RADIUS VALUE OUTSIDE ALLOW-
When the center of the arc was specified by I, J, and K for circular
interpolation, the length of the radius value exceeded nine digits.
5063 IS NOT PRESET AFTER REF. This message is output when the position counter has not been
preset before the start of plate thickness measurement. This alarm is
issued in one of the cases below.
1) When an attempt was made to perform measurement before a refer-
ence position had been established.
2) When, after manual reference position return, an attempt was made
to start measurement without first setting the position counter.
5064 DIFFERRENT AXIS UNIT
Circular interpolation was specified for a plane formed by axes using
different increment systems.
5065 DIFFERRENT AXIS UNIT
In PMC–based axis control, axes using different increment systems
are specified for the same DI/DO group. Modify parameter No. 8010.
5068 G31 P90 FORMAT ERROR No axis is specified for movement.
Two or more axes were specified for movement.
5073 NO DECIMAL POINT A decimal point is not specified for a command for which a decimal
point must be specified.
5074 ADDRESS DUPLICATION ERROR The same address appears more than once in a block. Alternatively,
a block contains two or more G codes belonging to the same group.
5082 DATA SERVER ERROR Details are displayed on the data server message screen.
5110 IMPROPER G–CODE
(G05.1 G1 MODE)
An illegal G code was specified in AI contour control mode.
5111 IMPROPER MODAL G–CODE
An illegal G code is left modal when AI contour control mode was speci-
5112 G08 CAN NOT BE COMMANDED
Look–ahead control (G08) was specified in AI contour control mode.
5113 CAN NOT ERROR IN MDI MODE
AI contour control (G05.1) was specified in MDI mode.
5114 NOT STOP POSITION
At the time of restart after manual intervention, the coordinates at which
the manual intervention occurred have not been restored.
5134 FSSB : OPEN READY TIME OUT Initialization did not place FSSB in the open ready state.
5135 FSSB : ERROR MODE FSSB has entered error mode.