4. DESCRIPTION OF PARAMETERS
B–63010EN/02
152
NOTE
1 If two or more points are pressed during a sampling period,
it is assumed that a mid point is pressed.
2 If a C executer application or the like has a touch panel drag
(move in pressed state) function, set this parameter to 0.
3 In open CNC, the parameter is valid just for CNC screen
display function.
TRA If a point on the touch panel is kept pressed for a time specified in
parameter No. 3197 or longer,
0 : P/S alarm 5303 is not raised.
1 : P/S alarm 5303 is raised.
NOTE
1 If an C executer application or the like has a touch panel
repeat (continue pressing) function, set this parameter to 0.
2 In open CNC, the parameter is valid just for the CNC screen
display function.
TBZ If a point on the touch panel is pressed,
0 : The buzzer does not sound.
1 : The buzzer sounds.
NOTE
This improvement is valid if the hardware is equipped with
a separate buzzer.
TB2 If a buzzer is provided and if bit 3 (TBZ) of parameter No. 3192 is set to 1,
0 : Pressing any point on the touch panel causes the buzzer to sound. If
any point is kept pressed, the buzzer continues sounding.
1 : The buzzer sounds when the pressing on the touch panel is recognized
as a key.
3197 Detection time of continuous pressing on touch panel
[Data type] Byte
[Unit of data] s
[Valid data range] 0 to 255
This parameter is valid if bit 2 (TRA) of parameter No. 3192 is set to 1.
Set a period of continuous pressing on the touch panel which causes
P/S5305 alarm to be raised. If 0 is set, a period of 20 s is assumed.
#7
MIP3201
#6
NPE
#5
N99
#4 #3
PUO
#2
REP
#1
RAL
#0
RDL
[Data type] Bit
RDL When a program is registered by input/output device external control
0 : The new program is registered following the programs already
registered.
1 : All registered programs are deleted, then the new program is
registered.
Note that programs which are protected from being edited are not
deleted.