4. DESCRIPTION OF PARAMETERS
B–63010EN/02
220
No. Parameters for low–speed characteristics if the spindle switch function is not used
or if the output switch function is used on the MAIN spindle when the spindle is
switched
(No.4136 to 4175)
Data type
4152 Word Conventional:Electromotive force compensation constant
HRV:Motor leak constant
4153 Word Conventional:Electromotive force phase compensation constant
HRV:Voltage compensation factor in high–speed area in steady state/Motor voltage fac-
tor in steady state
4154 Word Conventional:Electromotive force compensation velocity factor
HRV:Voltage compensation factor in high–speed area during acceleration/Motor voltage
factor during acceleration
4155 Word Conventional:Voltage compensation factor during deceleration
HRV:Reserved
4156 Word Temperature compensation gain
4157 Word Time constant for changing the torque
4158 Word Conventional:Maximum output limit zero speed
HRV:Maximum torque curve compensation factor
4159 Word Conventional:Secondary current factor during rigid tapping
HRV:Secondary current factor during rigid tapping
4160 Word Hysteresis of the speed detection level
4161 Word Conventional:Compensation factor for the phase of the electromotive force during decel-
eration
HRV:Velocity factor for the proportional gain of the current loop/Current phase lag com-
pensation constant
4162 Word Cutting feed velocity loop integral gain in Cs contour control (HIGH)
4163 Word Cutting feed velocity loop integral gain in Cs contour control (LOW)
4164 Word Conversion constant of the phase–V current
4165 Word Conventional:Time constant of voltage filter for electromotive force compensation
HRV:Time constant for changing the exciting current during deceleration/Time constant
for changing the exciting current
4166 Word Conventional:Regenerative power limit
HRV:Regenerative power limit in high–speed area/Regenerative power limit
4167 Word
4168 Word Overload current alarm detection level (for low–speed characteristics)
4169 Word Overload current alarm detection time constant
4170 Word Overload current alarm detection level (for high speed characteristics)
4171 Word Number of teeth of spindle gear (HIGH)
4172 Word Number of teeth of position detector gear (HIGH)
4173 Word Number of teeth of spindle gear (LOW)
4174 Word Number of teeth of position detector gear (LOW)
4175 Word Analog override zero level