5. OPERATION
0 Discompile the ROM format file after conversion, and the resultant file will become able to
be edited on the personal computer.
5.6.7.3
Memory card input/output function (PMC-RAl) for the PMC of the
CNC (L/R) with loader control
This function writes a loader control sequence program to, or reads it from, the FANUC Series 16-
MODEL B with loader control. The loader control sequence program can be edited by specifying
the model as PMC-RAl.
(1)
Writing (programmer - > memory card)
To write an L/R sequence program to a memory card, use the F8 key (L/R).
(The operations other than input/output with the memory card (such as editing) are the same
as those for the conventional PMC-RAl.)
[Operation]
(2)
Install a memory card interface in the personal computer.
Select [INOUT] (input!output) from the main menu.
Select [M-CARD] (memory card) from the input/output menu.
Specify the names of the desired ROM format file and memory card file. (The memory
card filename is specified in the form of memory card drive + filename.)
Write to the memory card using the F8 key (L/R).
WRITE fPROCRMfE%! - > Memory Card)
ROM FORMAT FILE NAME
: A:YDATAYSMfPLE. XEX
Memory Card FILE NAME
: D:YSAMPLE. XBF
(Specify the MEWRY CARD drive)
Fig. 5.6.7.3 Input/Output (to MC) Screen (model supporting loader control)
Reading (programmer < - memory card)
To read the loader control sequence program from the memory card, use the same operating
procedure as for the conventional PMC-RAl.
1-146