13.FUNCTIONS TO SIMPLIFY PROGRAMMING NC FUNCTIONS B-63322EN/03
- 146 -
G98(Return to initial level )
Initial level
Point R level
G99(Return to point R level)
- Repeat
To repeat drilling for equally-spaced holes, specify the number of
repeats in K_.
K is effective only within the block where it is specified.
Specify the first hole position in incremental mode (G91).
If it is specified in absolute mode (G90), drilling is repeated at the same
position.
Number of repeats L
The maximum command value = 9999
If K0 is specified, drilling data is stored, but drilling is not performed.
- Cancel
To cancel a canned cycle, use G80 or a group 01 G code.
Group 01 G codes
G00 : Positioning (rapid traverse)
G01 : Linear interpolation
G02 : Circular interpolation or helical interpolation (CW)
G03 : Circular interpolation or helical interpolation (CCW)