OPERATION
B–63834EN/02
12. GRAPHICS FUNCTION
625
WORK LENGTH (W), WORK DIAMETER (D)
Specify work length and work diameter. The table below lists the input
unit and valid data range.
W
D
X
Z
W
D
Z
X
Table 12.1 Unit and Range of Drawing Data
Unit
Increment system
mm input Inch input
Valid range
IS–B 0.001 mm 0.0001 inch
IS–C 0.0001 mm 0,00001 inch
0 to 99999999
GRAPHIC CENTER (X, Z), SCALE (S)
A screen center coordinate and drawing scale are displayed. A scale
screen center coordinate are automatically calculated so that a figure
set in WORK LENGTH (a) and WORK DIAMETER (b) can be fully
displayed on the screen. So, the user need not set these parameters
usually.
A screen center coordinate is defined in the workpiece coordinate
system. Table 12. 3. 2 indicates the unit and range. The unit of SCALE
is 0.001%.
PROGRAM STOP (N)
Set the sequence number of an end block when part of the program is
to be drawn. A value set in this parameter is automatically cancelled
(cleared to 0) once a drawing is provided.
AUTO ERASE (A)
If 1 is set, the previous drawing is automatically erased when
automatic operation is stated from the reset state. Then, drawing is
started.
LIMIT (L)
If 1 is set, the area of stored stroke limit l is drawn with
double–dot–and–dash lines.
GRAPHIC MODE (M)
This mode can not be used.
NOTE
The parameter values for drawing are preserved even if
power is turned off.
D Graphics parameter