1.MANUAL GUIDE 0i MANUAL GUIDE 0i B-63834EN/02
- 656 -
1.4.2.7 Figure block of Grooving in turning
Normal Groove : G1460
Data item Comment
C CHAMFER AMOUNT Chamfer amount of a groove (radius)
X START POINT X X-axis coordinate of a point where grooving starts
Z START POINT Z Z-axis coordinate of a point where grooving starts
U END POINT (X/Z-AXIS) X-axis or Z-axis coordinate of the end point of a
groove. This data is necessary only at the depth of a
groove is different. If no value is inputted, depth of
start point and end point becomes equal. X value is
used at outer groove, and Z value is used at end face
groove.
D GROOVE DEPTH Depth of a groove to be machine (radius)
W GROOVE WIDTH Width of a groove to be machined (radius)
M NUMBER OF GROOVE Number of grooves when more than one groove are
to be machined at regular intervals.
Y PITCH Distance between grooves when more than one
groove are machined. When minus value is entered,
grooves will be positioned from end face side toward
chuck side. When plus value, it will be reversed
(radius)
Trapezoidal Groove : G1461
Data item Comment
X START POINT X X-axis coordinate of a start point
Z START POINT Z Z-axis coordinate of a start point
A END POINT-1 (X-AXIS) X-axis coordinate of a 1st line from start point
B END POINT-1 (Z-AXIS) Z-axis coordinate of a 1st line from start point
C CORNER R 1 Corner-R radius of the end point of line-1
D CHAMFER 1 Chamfering amount of the end point of line-1
E END POINT-2 (X-AXIS) X-axis coordinate of a 2nd line from 1st end point
F END POINT-2 (Z-AXIS) Z-axis coordinate of a 2nd line from 1st end point
H CORNER R 2 Corner-R radius of the end point of 2nd line
I CHAMFER 2 Chamfering amount of the end point of 2nd line
J END POINT-3 (X-AXIS) X-axis coordinate of a 3rd line from 2nd end point
K END POINT-3 (Z-AXIS) Z-axis coordinate of a 3rd line from 2nd end point
L CORNER R 3 Corner-R radius of the end point of 3rd line
T CHAMFER 3 Chamfering amount of the end point of 3rd line
P END POINT-4 (X-AXIS) X-axis coordinate of a 4th line from 3rd end point
Q END POINT-4 (Z-AXIS) Z-axis coordinate of a 4th line from 3rd end point
R CORNER R 4 Corner-R radius of the end point of 4th line
S CHAMFER 4 Chamfering amount of the end point of 4th line
V FINAL POINT (X-AXIS) X-axis coordinate of a 5th line from 4th end point
W FINAL POINT (Z-AXIS) Z-axis coordinate of a 5th line from 4th end point
M NUMBER OF GROOVE Number of grooves when more than one groove are
to be machined at regular intervals.
Y PITCH Distance between grooves when more than one
groove are machined. When minus value is entered,
grooves will be positioned from end face side toward
chuck side. When plus value, it will be reversed