OPERATION
B–64144EN/01
8. DATA INPUT/OUTPUT
499
The floppy is provided with the write protect switch. Set the switch to
the write enable state. Then, start output operation.
(2) Write–enabled
(Reading, writing,
and deletion are possible.)
Write protect switch of a cassette
(1) Write–protected
(Only reading is
possible.)
Fig. 8.1 Protect swtich
Once written in the cassette or card, data can subsequently be read out by
correspondence between the data contents and file numbers. This
correspondence cannot be verified, unless the data contents and file
numbers are output to the CNC and displayed. The data contents can be
displayed with display function for directory of floppy disk
(See Section III–8.8).
To display the contents,write the file numbers and the contents on the
memo column which is the back of floppy.
(Entry example on MEMO)
File 1 NC parameters
File 2 Offset data
File 3 NC program O0100
⋅⋅
⋅⋅
⋅⋅
File (n–1) NC program O0500
File n NC program O0600
D Protect switch
D Writing memo