Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
1. DISPLAY AND OPERATION
81
System software can be replaced only with compatible system software.
Otherwise, the first time the Power Mate i is turned on after the system
software is replaced, the following screen will be displayed and the
system will not be activated:
88E001
SYSTEM LABEL CHECK ERROR:
CLEAR ALL SRAM MODULE
NOT READY
In this case, perform memory all clear (by holding down the
RESET
and
DELETE
MDI keys then turning on the power) or reinstall the original system
software.
NOTE
1 The system software is stored in the FROM on the memory
module.
2 This screen is unavailable with a combination of the
DPL/MDI and its operation package.
1.13
WARNING SCREEN
DISPLAYED WHEN
SYSTEM SOFTWARE
IS REPLACED
(SYSTEM LABEL
CHECK ERROR)

Leave a Reply

Your email address will not be published. Required fields are marked *