Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
1. DISPLAY AND OPERATION
85
The maintenance information can be read and punched.
When the maintenance information is input from or output to a memory
card, a file name MAINTINF.DAT is used.
(1)Format
%%
Data
(2)Reading
When a MAINTINF.DAT file generated in the format shown above is
read, the data is added at the end of the existing maintenance
information.
NOTE
1 A TAB code is converted to one to four blanks, depending
on the input position.
2 80h to 90h and E0h to EBh are assumed as prefix codes of
doublebyte characters. Reading these codes alone is
inhibited.
3 Control codes (00H to 1FH) except TAB and LF are
discarded in reading.
4 %% cannot be input.
(3)Punching
All maintenance information is output in the format shown above.
In the Power Mate i, the following maintenance information is factoryset
in the FROM.
D Customer name
D Basic unit specification
D Serial number
D Contract number
D Test date
D Manufacturing month
D Base PCB specification and version
D Option board specification and version
D Software specification and version
D Backpanel, card, and module specifications
D Ordering information
1.14.2
Maintenance
Information
Input/Output
1.14.3
Factoryset
Maintenance
Information

Leave a Reply

Your email address will not be published. Required fields are marked *