Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
1. DISPLAY AND OPERATION
87
If the β servo amplifier is connected to Power Mate i, it is possible to
display and set up the data related to the slave function on the Power Mate
i side, using the Power Mate CNC manager.
The power motion manager enables the following display and setting:
(In this case, the Power Mate i must be equipped with the CRT/MDI. A
combination of the DPL/MDI and its operation package does not support
this display and setting.)
(1)Current position display (absolute/machine coordinates)
(2)Parameter display and setting
(3)Diagnosis display
(4)System configuration screen display
(5)Alarm display
#7
0960
#6 #5 #4 #3
PMN
#2
MD2
#1
MD1
#0
SLV
[Data type] Bit
SLV When the Power Mate CNC manager is selected, the screen shows the
data of:
0 : A single slave.
1 : Up to four slaves by dividing the screen into four segments.
MD1, MD2 The slave parameters are input from and output to the following devices:
MD2 MD1 I/O device
0 0 Part program storage
0 1 Memory card
The parameters are input or output in the program format, no matter which
I/O device is selected.
PMN The Power Mate CNC manager function is:
0 : Enabled.
1 : Disabled. (Communication with the slave is not performed.)
1. Press the
SYSTEM
function key.
2. Press the continuous menu key
several times. The [PMM] soft
key appears.
3. Press the [PMM] soft key. The system configuration screen, which is
the initial screen of the Power Mate CNC manager, appears. The
screen has the following soft keys (function selection soft keys).
[ POS ][ ][ ][SYSTEM][ MSG ]
1.15
POWER MATE CNC
MANAGER
1.15.1
Parameter
1.15.2
Screen Display

Leave a Reply

Your email address will not be published. Required fields are marked *