Fanuc Power Mate i-D/H Maintenance Manual

1. DISPLAY AND OPERATION
B63175EN/03
88
The currently active soft key is displayed in reverse video. Pressing a soft
key enables the corresponding function, as indicated below:
POS: Current position display
SYSTEM: System information
MSG: Alarm list
To select another function after one of the functions listed above is
selected, press the return menu key
several times until the soft keys
are displayed as shown above. Then, select the desired function.
4. To terminate the Power Mate CNC manager, repeatedly press the
return menu key
until the function selection keys are displayed
as shown above. Then, press the return menu key once more. The soft
keys appear, and the Power Mate CNC manager terminates. The
system configuration screen of this function is displayed as the
termination screen.
Alternative termination method is to select another function while this
function is enabled. To do this, press an MDI function key (
POS
,
PROG
,
MESSAGE
, etc.).
NOTE
After another screen is displayed by pressing a function key,
pressing the
function key, restores the initial status
of this function. That is, the soft keys shown above are
restored. The data that was being input is canceled.
SYSTEM
This screen displays the system software information of the slave. The
screen is displayed first when the Power Mate CNC manager function is
selected. This screen is automatically displayed also at the termination
of the function.
1. Press the [SYSTEM] function selection soft key. The following soft
keys are displayed together with the screen displayed when SYSTEM
was last selected. The currently active soft key is displayed in reverse
video.
[ PARAM ][ DGNOS ][ ][SYSTEM][ ]
D System configuration
screen

Leave a Reply

Your email address will not be published. Required fields are marked *