Fanuc Power Mate i-D/H Maintenance Manual

1. DISPLAY AND OPERATION
B63175EN/03
90
D Searching for a parameter
A search can be made for the parameter to be displayed.
1. Select the active slave.
2. Press the [(OPRT)] soft key. The following soft keys appear.
[ NO.SRC ][ ][ ][ ][ INPUT ]
3. Enter a desired number in the keyin field by using MDI numeric keys.
Then, press the [NO.SRC] soft key. The search starts.
D Setting a parameter
A parameter of a slave can be directly set from the Power Mate i.
1. Select the active slave.
2. Press the [(OPRT)] soft key. The following soft keys appear:
[ NO.SRC ][ ][ ][ ][ INPUT ]
3. Move the cursor to the parameter to be set.
4. Enter desired data in the keyin buffer by using MDI numeric keys.
Then, press the [INPUT] soft key. Alternatively, press the MDI
INPUT key.
This screen shows the current status of the slave.
1. Press the [SYSTEM] function selection soft key. The following soft
keys appear:
[ PARAM ][ DGNOS ][ ][SYSTEM][ ]
2. Press the [DGNOS] soft key. The diagnosis screen appears. The
displayed data is basically the same as the data displayed on the
parameter screen.
For details of the diagnosis information, refer to the maintenance
manual of the corresponding slave.
D Diagnosis screen

Leave a Reply

Your email address will not be published. Required fields are marked *