Fanuc Power Mate i-D/H Maintenance Manual

1. DISPLAY AND OPERATION
B63175EN/03
92
The active slave is subjected to the ZOOM function, which will be
described later, and parameter overwrite. The title of the active slave is
displayed in a color different from the display color of the other slave
titles.
The active slave can be selected by pressing the [±NEXT] or [°BACK]
soft key, which is displayed after the continuous menu key
is
pressed several times.
[±NEXT]: Displays the screen of the Power Motion unit connected after
the currently active slave. The equipment other than the
Power Motion unit is ignored.
[°BACK]: Displays the screen of the Power Motion unit connected
before the currently active slave.
Whether the screen displays the data of just a single unit or of four units
in four segments is specified in the SLV bit (bit 0 of parameter 960).
To switch the fourslave display to the singleslave display, press the
[ZOOM] soft key, which is displayed after the continuous menu key
is pressed several times. The singleslave display shows the data of the
active slave. To switch the singleslave display to the fourslave display
showing the data of four slaves including the active slave, press the
[ZOOM] key.
When five or more slaves are connected, the fourslave display has two
or more pages. To see the slave data that is not displayed on the current
page, press soft key [±NEXT].
DGNOS
4.GROUP3 / β
SYSTEM 88A101
1.GROUP0 / β
SYSTEM ****##
2.GROUP1 / β
SYSTEM 88A101
POWER MATE CNC MANAGER
SYSTEM CONFIGURATION
O12345678 N12345
3.GROUP2 / β
SYSTEM 88A101
PARAM SYSTEM
D Operating the active
slave
D Singleslave display/
Fourslave display

Leave a Reply

Your email address will not be published. Required fields are marked *