Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
1. DISPLAY AND OPERATION
93
POWER MATE CNC MANAGER O12345678 N12345
SYSTEM CONFIGURATION
1.GROUP0 / β
SYSTEM <SERIES/VERSION> 88A101
[ POS ][ DGNOS ][ ][ SYSTEM ][ MSG ]
While the following soft keys are being displayed, a guidance message
is displayed in the message field.
[ POS ][ ][ ][SYSTEM][ MSG ]
[ WORK ][ ][MACHIN ][ ][ ]
[ PARAM ][ DGNOS ][ ][SYSTEM][(OPRT) ]
When the soft keys are displayed as shown above, SELECT ACTIVE
SLAVE [>] is displayed.
[ ±NEXT ][ ° BACK ][ ZOOM ][ ][ ]
When the soft keys are displayed as shown above, SELECT ACTIVE
SLAVE [] [] is displayed.
When the [(OPRT)] soft key is pressed, the message line may turn into a
keyin field as required. The numeric data input by using MDI keys is
displayed after the prompt (>).
On the parameter and diagnosis screens, the keyin field appears when
just a numeric value is input. The soft key [(OPRT)] need not be pressed.
D Guidance message
D Keyin field

Leave a Reply

Your email address will not be published. Required fields are marked *