Fanuc Power Mate i-D/H Maintenance Manual

1. DISPLAY AND OPERATION
B63175EN/03
94
Slave parameters can be saved in builtin SRAM of Power Mate i or a
memory card as a data file of program format. Specify the first digit of
the registration program number in parameter 8760. Programs with
predetermined numbers are created for individual slaves. When the
parameters are saved in builtin SRAM, a program having the specified
program number is created. When the parameters are saved in a memory
card, a file is created, to which the file name consists of the specified
program number and an extension PMM.
Example: When parameter 8760 is set to 8000
The program number for group n is 8000 + n*10.
The group number n is indicated in the title area of each slave.
CAUTION
In case that the parameters are saved in a memory card, If
the specified program number already exists on memory
card, the corresponding program is overwritten with new
data.
Specify a desired input device in the bits 1 (MD1) and 2 (MD2) of
parameter No. 960. Connect a memory card. Alternatively, check the free
area of builtin SRAM. Then, follow the steps given below:
1. Select the active slave.
2. Press the [(OPRT)] soft key. The following soft keys appear:
[ NO.SRC ][ ][ ][ ][ INPUT ]
3. Press the continuous menu key . The following soft keys appear:
[ ][ READ ][ PUNCH ][ ][ ]
4. Press the [READ] soft key. The following soft keys appear:
[ ][ ][ ][CANCEL ][ EXEC ]
5. Press the [EXEC] soft key.
During input, INPUT blinks in the message field.
1.15.3
Parameter Input/Output
D Saving parameters

Leave a Reply

Your email address will not be published. Required fields are marked *