Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
1. DISPLAY AND OPERATION
99
G10 L61 Px [n]
x Registration number
n Item name
[Alphanumeric characters*twobyte
characters*alphanumeric characters]
(b)MDI keypadbased registration
An item name can be registered on the machine system menu
screen by first entering it in the following format, then pressing
soft key [INPUT] (or
INPUT
function key).
Pressing soft key [+INPUT] adds the item name to the list of
previously registered item names.
Alphanumeric characters*twobyte characters*alphanumeric characters
The twobyte characters shall comply with the FANUC code.
(See Section 1.19.6.)
When entering a twobyte character, sandwich it with an *
pair.
The item name can consist of up to 24 alphanumeric characters
(if no twobyte character is included) or 12 twobyte characters
(if no alphanumeric character is included).
Example) To register LCD backlight, enter:
>LCD*110E10F410CC114010B610FE_
NOTE
1 * cannot be used in item names, because it is used as
control code. [, ], (, or ) also cannot be used in item
names.
2 When both alphanumeric and twobyte characters are
used in an item name to be registered, the warning
message DATA IS OUT OF RANGE may appear even if
the maximum allowable number of characters has not been
exceeded.
3 If a blank item name is selected from the machine system
screen, the warning message EDIT REJECTED appears.
If a blank item name is selected from the NC system screen,
a blank is set up.
Format
Format

Leave a Reply

Your email address will not be published. Required fields are marked *