Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
2. HARDWARE
119
The Power Mate i has the following LEDs and switches.
LEDM1 displays the status information of the Power Mate. It is used
along with the MTSW rotary switch and PSW pushbutton switch also to
control setting and maintenance operations.
LEDM2 is used to indicate that the 24 VDC input power fuse in the
control unit has blown. See Section 2.7.1 for how to replace the fuse.
MTSW is a rotary switch used along with the LEDM1 7segment LED
indicator and the PSW pushbutton switch for setting and maintenance
operations. Normally, set the switch to the 0 position.
PSW is a pushbutton switch used along with the LEDM1 7segment LED
indicator and the PSW pushbutton switch for setting and maintenance
operations.
NOTE
For details on the LEDM1, MTSW, and PSW, see
SETTING/DISPLAY/MAINTENANCE USING THE MAIN
UNIT OF THE Power Mate i, in Appendix F.
2.2.3
LEDs and Switches on
the Control Units
D 7segment LED (LEDM1)
D Blown fuse indication
LED (LEDM2)
D Rotary switch (MTSW)
D Pushbutton switch
(PSW)

Leave a Reply

Your email address will not be published. Required fields are marked *