Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
122
Name RemarkStorage locationSpecification
Application software for the
PROFIBUSDP slave/master
function
A02B0259J550#6557 Memory module NC software for the PROFIBUSDP
slave/master function
Control software for the
PROFIBUSDP slave function
A02B0259J552#6553 Memory module Firmware for the PROFIBUSDP
slave function
Control software for the
PROFIBUSDP master function
A02B0259J551#6557 Memory module Firmware for the PROFIBUSDP
master function
Application software for the
DeviceNet function
A02B0259J553#6576 Memory module NC software for the DeviceNet
function
Control software for the DeviceNet
slave function
A02B0259J554#6570 Memory module Firmware for the DeviceNet function
Control software for the Ethernet
function
A02B0259J555#6561 Memory module Firmware for the Ethernet function
Control software for the fast
Ethernet function
A02B0259J555#6567 Memory module Firmware for the fast Ethernet
function
Control software for the FLnet
function
A02B0259J566#6564 Memory module Firmware for the FLnet function
Application software for the
FLnet or I/O LinkII function
A02B0259J568#654I Memory module NC software for the FLnet or I/O
LinkII function (I/O LinkII is
provided for A02B0259J282.)
CAUTION
1 The system software of which storage location is the memory module is stored in the FROM
on the memory module. When replacing the memory module, make sure that the functions
stored on the replacement module are of the same version as before or of a later version.
Otherwise, they may be inoperable. (The version of the software has nothing to do with the
general version of the printedcircuit board.)
2 The boot software is stored in the FROM on the CPU card. When replacing the CPU card, make
sure that the function stored on the replacement CPU card is of the same version as before or
of a later version. Otherwise, it may be inoperable. (The version of the software has nothing
to do with the general version of the printedcircuit board.)
3 The installed boot software may vary depending on the type of the CPU card. When replacing
the CPU card, make sure that the replacement CPU card is also a Power Mate i CPU card.
Note that the 16i/18i/21i CPU card cannot be used in place of the Power Mate i CPU card.

Leave a Reply

Your email address will not be published. Required fields are marked *