Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
2. HARDWARE
141
NOTE
Refer to FANUC DeviceNet Board OPERATORS
MANUAL (B63404EN) for details.
Refer to FANUC DeviceNet Board OPERATORS
MANUAL (B63404EN) for details of DeviceNet board C.
Name Specification
DeviceNet board A20B81000490
DeviceNet board B A20B81000491
NOTE
1 There are two DeviceNet boards: the DeviceNet slave
board and DeviceNet master board. Only the difference
between these boards is the connection position of the
setting pin TM1 on the board. The printedcircuit board
specifications of these boards are the same. (Their unit
specifications differ.)
2 The DeviceNet board must be mounted and dismounted by
following a specified procedure. See Section 2.6.5.
LED A
LED 3
LED 2
LED 1
DeviceNet
connector TBL
LED MNS
LED HEALTH
Connector for
connection with
the backpanel,
JNA
Internal daughter board
Setting pin TM1
This board provides three green LEDs and one red LED for status
indication. In addition, two LEDs that light in both red and green are
provided on the internal daughter board. The meanings of the LEDs are
listed below.
2.3.12
DeviceNet Board (B)
D Specification
D Connector and LED
locations

Leave a Reply

Your email address will not be published. Required fields are marked *